top of page

My First Stamped Concrete Patio, Six Years Later

Writer: Matt Weber
Matt Weber
5 hours ago
3 min read

By Alex Semenov, HomeJect


Six years ago, the back of our house in Overland Park, Kansas, was just grass, an old wood deck, and a lot of ideas. I wanted one big outdoor pad that would tie the whole backyard together, and I wanted to do as much of it as I could myself. I had never done stamped concrete before.


It took me about three months.


Most of the work happened before any concrete showed up. I dug out and graded the area myself, then hauled in the base rock with my own trailer, one load at a time, and compacted it. I built the forms, using wood for the straight runs and flexible forms staked along the curves.


Then, I tied rebar across every section and set it up on chairs so the steel would end up inside the slab, not lying on the gravel. While everything was open, I ran water and electrical lines to the spots where I knew I'd want them later.


I poured in sections instead of all at once, with a crew helping on pour days. With stamped concrete, you're racing the clock, so the extra hands mattered. Doing it in sections also meant I got better with every pour.


For color, I used integral color mixed right into the concrete, a deep reddish base, with terracotta and a hot chili pepper color on top. The stamp is a Roman slate pattern. It's a natural stone texture, and honestly, it forgives a first-timer's mistakes. I also pressed in some grape clusters and animal prints here and there, and set in a couple of medallions, a compass and a sun.


That was six years ago. It's been through Kansas summers, hard freezes, and a lot of backyard parties, and it's still solid. The color and pattern are still there.


If I were to offer someone attempting it for the first time one piece of advice: Spend your energy on the prep work. The base, the forms, and getting the rebar at the right height are what you'll be thankful for years later. And run your lines before you pour, because cutting into finished concrete is no fun.


That patio ended up being the starting point for everything else we built back there, but that's another story.




A Quick Look at the Stamping Tools

My goal was stamped concrete — colored, stamped, stone-imitation. (I bought all my stamps instead of renting, because the project was going to take forever, and renting them for months just wasn’t economical.) For the main pattern, I went with Roman slate and bought four skins from Amazon. Roman slate is great for a DIYer because it’s a seamless texture pattern — unlike brick or cut-stone stamps, the pieces don’t all have to line up perfectly with each other. You can lay the skins however you want, in any order, and it still reads as one continuous stone surface. They also come with the little edge (touch-up) skins.



For the borders, I used a grape pattern, and I picked up a couple of animal-print stamps — iguanas, butterflies, and dinosaur footprints — that I placed here and there. But the main workhorse was Roman slate.


I also bought a tamper, a couple of stamped texture rollers, and a dedicated release-agent sprayer (a garden-type sprayer).


The Decorative Medallions (Rented, Not Bought) — I also used a lot of decorative stamped medallions as feature pieces. These are big — about 40 inches in diameter — and I went with round ones. I used a couple of compass medallions, a couple of sun medallions, and one pinwheel.


--

Find more photos and extensive details of this awesome stamped concrete patio project at www.homeject.com!

Comments


Commenting on this post isn't available anymore. Contact the site owner for more info.
HIRlogoNEW.jpg

© 2026 Pine Mountain Media. All rights reserved. 

bottom of page